A US electric motor manufacturer asked Prosig to integrate an end-of-line vibration test that qualifies every motor model against its own limits and checks gearbox gear tooth contact frequencies.
Project at a glance
- Customer: Electric motor manufacturer
- Location: USA
- Applications: End-of-line testing; Manufacturing and industrial; Advanced engineering
- Products used: DATS hardware; DATS software
Background
Prosig was contracted by a US-based electric motor manufacturer to integrate an end-of-line vibration test system for the motors it builds.
The challenge
Every motor under final test had to be qualified to confirm its vibration levels were within specification. The customer needed to switch quickly between numerous motor models, each with its own pass/fail limits, and also test gearboxes to evaluate gear tooth contact frequency.
The solution
Motors
A simple pass/warn/fail test was implemented, based on single-channel overall RMS vibration levels. Warning and fail limits are stored in a CSV file, and the test software recalls the right values for the motor model the operator selects.
Gearboxes
A more involved test was designed for the gearboxes. It measures the vibration signal, calculates the vibration spectrum, integrates the signal to velocity, identifies the 1x and 2x gear tooth contact frequencies and evaluates each one against the specified velocity vibration levels.
The flexibility of the DATS software means every configuration of motor and gearbox can be tested on the same system.
The results
- Speeded up testing
- Works for all configurations of product
- Automatic recording of results
- Automatic test reports
The DATS test system lets the manufacturer test all its motors and gearboxes quickly, accurately and consistently, and has greatly sped up end-of-line testing.
